Occasionally it may be helpful to power cycle the device to restart the processor. This can be needed if an over-the-air update has failed, or as a result of a brown out from unusual line power surges.
The method for power cycling the device depends on the device type. Look for your device type below:
- Plug in switches: Unplug and re plug the device from the wall
- In wall switches: First push the buttons, if that does not work, then cycle the circuit breaker for those lights.
- Installed light fixtures: If your wall switch has a power cycle tab (a little tab around the edge of the switch. If you pull it out the power will be disconnected to the lights. Jasco dimmer switches, Avi-on Scene Controllers have this tab. If there is no disconnect tab, then cycle the circuit breaker that the light is connected to.
- Motion Sensors: Follow the instructions for installed light fixtures.
Note, Power Cycling is not the same as a Hard Reset.
A power cycle may restore function if the the unit is stopped and will not harm the device or system in any way.
A hard reset will NOT improve the device condition and will result in breaking the link between the user account and device. We do not recommend performing a hard reset except in specific conditions where you wish to add the device to a new user account and do not have access to the original account login credentials.
0 Comments